Eusso UGL2430-UHM Manual do Utilizador descarregar pdf (Página 9)

2. PC Configuration

To communicate and configure 802.11n AP router, the PC on your LAN must

install TCP/IP protocol. Make sure the TCP/IP protocol of the PC is configured

for Obtain IP address from DHCP and is connected to LAN (Ethernet) port of

the AP router. In doing so, the PC obtains an IP address of 192.168.1.1 from

802.11n AP router.

The 802.11n AP router assumes an IP address of 192.168.1.1 without network

connectivity. This IP address is used for communicating with the 802.11n AP

router via the web UI or Telnet, with the PC connected to the LAN port.

The 802.11n AP router assumes a DHCP IP address on the WAN side if

connected to the network. In this case user can communicate with the same

IP address 192.168.1.1 with PC connected to the LAN port. PC in the network

can communicate with the DHCP IP address allocated to 802.11n router.

2.1 TCP/IP Networking Setup

Checking TCP/IP Settings for Windows 9x/Me

a) Select “Start Æ Control Panel Æ Network”, the window below will appear,

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Sem comentários

Eusso UGL2430-UHM Manual do Utilizador Página 9